EMC Real World Again

[Ethan Vos <ethan-at-forward.ca>]

Well after much discussion with PacSci I know what's happening. The 
Compumotor Zeta drivers in the machine I have is micro-stepping the motors 
25:1 or 5,000 pulses to 200 pulses.

What will happen if I drop the ratio down to 5:1? How much rougher will the 
motor run? Will it be noticeable?

If I go to servos, what are the best drivers? Will the STG board drive the 
servos direct or do I also need an outside power supply?

Ethan