Re: EMC for lasercutting /urgent

[Jacob Kranendonk <j_kranendonk-at-yahoo.com>]

Hi Ray, Paul, ....

I think with your help offered (thanks for this) I
will make it. But first, the main problem we should
focus on is this delay in axis movement after a M3/M5
or M8/M9 command. I wonder if the "signaling" to the
GUI of these comands have anything to do with it? If
this is the problem could an other M command be used
for switching the laser? To use an "open" M command
for switching the laser is preferebly anaway. So, how
can we find out what causes this delay, and how to
overcome it???


__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/