Re: No Parallel Port

Subject: Re: No Parallel Port
From: Paul <Paul.Corner-at-tesco.net>
Date: Mon, 28 May 2001 12:01:27 +0100
Content-Transfer-Encoding: 8bit
Content-Type: text/plain
In-Reply-To: <000701c0e71b$cd335300$a000a8c0-at-pdwhome.com>
References: <NDBBLCIMBBDABGEAFDAAOEEJEMAA.timg-at-ktmarketing.com> <01052708242900.18477-at-localhost> <000701c0e71b$cd335300$a000a8c0-at-pdwhome.com>
Reply-To: paul.corner-at-tesco.net

Hi Phil

There is, in the dropbox at www.linuxcnc.org a document from Karl Klemm that
gives a brief description of most of the ini file entries. The paper is
entitled "The Transfer of Technology to Small and Medium Sized Manufacturers"
and should be in the dropbox as iqp.pdf - see pages 61 onwards.

Regards, Paul.

On Mon, 28 May 2001, phil wrote:

> I'm looking for documentation for the INI file so I can setup the motors
> correctly. Forgive me if  I've missed something but looking through the
> handbook and the EMC site I can't find a comprehensive description of the
> INI file parameters. Is there one available ?

Follow-Ups:
- kernel 2.4
  - From: "Ian Wright" <Ian-at-iw63.freeserve.co.uk>

References:
- RE: No Parallel Port
  - From: "Tim Goldstein" <timg-at-ktmarketing.com>
- RE: No Parallel Port
  - From: Ray <rehenry-at-up.net>
- Re: No Parallel Port
  - From: "phil" <philw3-at-home.com>

Prev by Date: Re: Threading under EMC
Next by Date: Re: Threading under EMC
Prev by thread: Re: No Parallel Port
Next by thread: kernel 2.4

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact