Re: MasterCAM post processor for EMC, anyone?

Subject: Re: MasterCAM post processor for EMC, anyone?
From: Ray <rehenry-at-up.net>
Date: Wed, 28 Mar 2001 14:54:18 -0600
Content-Transfer-Encoding: 8bit
Content-Type: text/plain
In-Reply-To: <008c01c0b780$c23bcdd0$91ccc2ca-at-pc1>
References: <008c01c0b780$c23bcdd0$91ccc2ca-at-pc1>
Reply-To: rehenry-at-up.net

On Wed, 28 Mar 2001, Darrell wrote:
> 
> Fred,
> Test this post and let me know the results.
> Darrell

The MasterCam post is available.

www.linuxcnc.org/Dropbox/EMCMpfan.zip

If you use MasterCam and EMC please test it on some of your stuff and get
back to Darrell.   <dgehlsen-at-earthlink.net>

Ray

References:
- Re: MasterCAM post processor for EMC, anyone?
  - From: "zhang_sdu" <crzhang-at-sdu.edu.cn>

Prev by Date: Re: BDI Must haves
Next by Date: Inactive parellel port
Prev by thread: Re: MasterCAM post processor for EMC, anyone?
Next by thread: I found the problem with IOSH on RedHat 6.2

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact