STG2

[JohnDRoc-at-aol.com]

Following Ray's setup instructions (very helpful), I have June-EMC running 
with the 2.2PPK on what was originally a RH6.0 install.  Since I am doing a 
retrofit on an old Milltronics, I decided to try one axis first, before going 
all-out.  I don't have the limit switches hooked up, so I set the Min/Max 
polarities to 0 in the .ini file.  However, even with them set to 0 and no 
switches connected, I get a Max Hardware Limit Exceeded error.  If I didn't 
know any better, I'd say it sounds like there is a short in the STG2 board.  
Has anyone come across this?  Thanks.

-John