Re: Colored pins for EMC map-- reply with city, state, country

["Frank Hess" <hess-at-flatplate.com>]

Matt:

Just wanted to let you know that this machine _is_ still being used
daily. We still have occasional runaways, but we haven't replaced any
servo-motors or encoders lately.

A recent discussion on this forum centered around my question about
cutter radius comp.  Seems the version of emc I'm running won't let you
make a z-axis move after the comp is activated.

Frank

----- Original Message -----
From: "Matt Shaver" <mshaver-at-erols.com>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: Tuesday, February 15, 2000 04:14
Subject: Re: Colored pins for EMC map-- reply with city, state, country


> I'm sure Fred is acutely (painfully?) aware of these machines, but for
sake
> of completeness and the interest of folks reading this thread:
>
> Bridgeport V2E3 Knee Mill at Flatplate, Inc in York, PA.
> http://users.erols.com/mshaver/v2e3.htm
> This was my original machine and, for reasons that are rather complex, may
> not exist anymore. I would suggest either a black or bronze colored pin
for
> this machine.
>