Re: individual velocities

[Clint Bach <clintbach-at-earthlink.net>]

It sounds like it's time to upgrade to the latest version.  The next one
should have most of the problems fixed!!!  When is the next version due
out?

Tim Goldstein wrote:
> 
> I have a similar situation. X & Y good for 60 + ipm, but Z maxes out around
> 24 ipm (30% greater steps per inch and a drive mechanism with a LOT more
> drag). The problem with setting MAX_VELOCITY to 60 is any G0 move on the Z
> axis will be implemented as a move at 60 ipm.
> 
> Matt had mentioned that you are suppose to be able to throttle back an axis
> now (as of the Jan-2000 build) by putting a parameter in the individual axis
> entries under MIN_OUTPUT and MAX_OUTPUT. I have tried this on my Z axis, but
> it just seems to cause me follow errors that I can't get around.
> 
> Tim
> [Denver, CO]
> 
> > -----Original Message-----
> > From: Jon Elson [jmelson-at-artsci.wustl.edu]
> > Sent: Tuesday, February 08, 2000 10:26 PM
> > To: Multiple recipients of list
> > Subject: Re: individual velocities
> >