Re: Pre Release version of new GUI.

["Ian Wright" <Ian-at-iw63.freeserve.co.uk>]

Hi Ray,

I have attached copies of the two relevant files which I have changed to add
fixed jogging keys for the A axis - Insert and Delete as up and down. You
may or may not want to put these in your distribution.
One 'problem' I have noticed is that G0 doesn't seem to work in MDI mode -
where would this be controlled from?
The 'bouncing' of the last couple of digits in the numeric display is quite
annoying and makes it a bit difficult to decide just where things are, Is
this maybe just a case of increasing the display refresh rate?

Ian
--
Ian W. Wright
Sheffield  UK
www.iw63.freeserve.co.uk
----- Original Message -----
From: "Ray" <rehenry-at-up.net>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: 06 October 2001 18:45
Subject: Re: Pre Release version of new GUI.


>
>
> Thanks Ian
>
> If the focus is on one of the extra axes then + and - will jog it in the
> same way these keys do the others.  I did not attempt to define fixed jog
> key bindings like axis 0, 1, 2.  BTW - These will work for xzc if you were
> running a lathe.
>

exSetKeyBindings.tcl

exJog.tcl