RE: following error problem

[Tim Goldstein <tgoldstein-at-mlh-services.com>]

As you increase the steps per inch you have to also up the P values.
 
Tim
[Denver, CO]
 

-----Original Message-----
From: Donald Brock [don.pat.brock-at-prodigy.net] 
Sent: Sunday, September 23, 2001 12:02 AM
To: Multiple recipients of list
Subject: following error problem


Hello to all,
 
I have an earlier version of EMC now somewhat operational with a small
stepper setup for experimentation purposes.
 
Tim and Ray have been very helpful in getting me this far.
 
I am running linux 2.0.36, june 2000 EMC release, rtlinux_09J. I am using
freqmod.
 
I can run with out errors if I set INPUT_SCALE and OUTPUT_SCALE to a value
of  1000. If I set thes values to 4000 to reflect 4000 pulses(steps) per
inch for a 1/2-10 acme lead screw I get following errors.
 
Can someone give me an idea of what other variables I may need to change to
get this to work?
 
Thanks,
 
Donald Brock