Re: STG I or II

[Paul <Paul.Corner-at-tesco.net>]

Hi Enrique

Comments below:

>   I'm thinking of retrofit a BrigdePort (TEXTRON 11682001) and using
> EMC sounds like a great idea, my question here is whether use a STG I
> or II card, what I have read is support for model II is not yet
> available, is this correct, if not pls let me know.

If this is the same as my Bridgeport - Fitted with Heidenhain controls - You
will also need to add encoders or linear scales to your shopping list. The
standard encoders that are fitted to the end of the servo motors have a sine
wave output that cannot be used with EMC without additional hardware.
The STGII card is allready supported in the current releases of EMC, so that
part is not a problem.


> ps. Also, I know this forum is devoted to EMC and I apologize to you
> all guys, but does Bridgeport has a comercial solution to convert this
> or any of its machines?

Short answer is yes - You will probably be refered to a second party who can
fit a newer control. Bad news is it will cost a minimum of £5000 - That was the
starting figure I was quoted. 

Regards, Paul.